I have Dell LCD monitor with a fault that when it when it went sleeping mode, and then after i move the mouse or press the any on the key board it does not come active mode. You have to use a slow blow fuse and if the fuse keep blowing again then direct replace the posistor. Now, the question is, is there a problem with the fuse that I replaced? The original fuse has a powder inside and cased with something like a porcelain. Well, I guess there are no problems with my internal circuits on my monitor. When I inspected the fuse, there are no black or brown color on the glass fuse. I replaced my 3.15A 250VAC defective fuse with same rating glass fuse. I have encountered a problem regarding a fuse on my monitor. You have to use a coil tester to test the transformer primary winding. It could be a shorted primary winding in the power transformer or other semiconductor at the secondary side. Now I have a problem in two Monitors the problem is ashort in the power supply I looked at the power supply primary side and found mosft k2645 ,ic u3842, some zener shorted I exchanged all bad components with new one, and checked it agine to sure they all good but when I connect the power I found the short again. I repaired some Monitors and televisions. First Allow me to congratulate you on this excellent site with the wishes you continued success and progress.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |